Hoover 7128-02 Manual De Instrucciones página 7

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

3. Refer to wiring diagram on page 4. Remove the juction
box cover. Using wire nuts, connect house electrical wires
to ventilating fan wires; black to black, white to white,
green to green. Replace the junction box cover. (FIG. 3)
CAUTION: If your house wires do not match these colors,
you must determine what each house wire represents
before connecting and you may need to consult an
electrical contractor to determine this safely. Mount
junction box cover carefully so lead wires are not
pinched.
4. Install a circular duct and secure it with duct tape or
clamps.
5. Finish ceiling work. Ceiling hole should be flush with the
edge of the flange. (DO NOT FLUSH MOUNT TO JOIST.
Flange should be flush with ceiling board.) See
dimensions for ceiling hole on page 4. (FIG. 4) If
joist is present, insert longwood screws through
flange and through ceiling to secure fan to joist.
6. Install bulbs (not included) and attach the cover.
(FIG. 5)
7. Attach plug connector to receptacle. (FIG. 5-1)
8. Pinch mounting springs and insert into narrow
rectangular slots inside the fan housing next to
the fan motor (FIG. 5-2).
9. Turn on electricity at breaker box after
finishing installation.
www.homewerksww.com
Instructions
Receptacle
Flange
Ceiling
Plug connector
FIG. 5-1
Duct
black, white,
green
Long wood
screws
Ceiling
FIG. 5
Flange
Slot for
mounting
FIG. 5-2
Wiring box
Fan body
black, white,
green
FIG. 3
Flange
Ceiling
FIG. 4
Mounting
spring
Grille
7

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido