QFX ECH-1 Manual De Instrucciones página 2

AUX-in USB charge port
Charging the ECH-1
1- Connect ECH-1 to USB adapter (not included) with the USB cable supplied.
Make sure using original USB adapter from Echo dot.
l
l Or use other USB adapters that rated at 5V, output from 1.5A to 2.5A.
2- Power indicator turns red during charging, and turns off after fully charged.
3- Unplug USB cable after fully charged.
4- Power button indicator flashes red when battery is low power (<21%).
Turn on/off ECH-1
1- Press and hold power button to turn on the speaker.
2- Press and hold again to turn off.
Switch mode
1- Switch on ECH-1, Bluetooth indicator flashes blue slowly, the device is under Echo Dot mode.
2- Press power button to go to Bluetooth mode, Bluetooth indicator flashes blue rapidly.
3- Press power button again to go to AUX mode, power indicator flashes red slowly.
Connect ECH-1 with Amazon Echo Dot
1- Open the silicon cover to install Echo Dot into the docking station properly.
USB power pin
2
Line-in pin