Setting The User Code; Mounting Method - First Alert 1037275 Guía De Instalación Y Operación

Setting The User Code

CLOSING DOOR
Turn the knob counter clockwise to close the door.
1
AUTOMATIC LOCK OUT PERIOD
For added security, the safe will automatically lock out entry if the wrong
password is entered multiple times
3 continuously wrong entries will activate the warning beep for 20 seconds.
1
6 continuously wrong entries will activate the warning beep for 5 minutes.
2
CAUTION
The key pad would be disabled during the beeping. You can only stop the beeps
by opening the safe with the emergency key and cut power by removing the
batteries.
SETTING THE USER CODE
With the door open, press the reset button once, start setting the code when
1
the yellow light goes on.
Input new code (3-8 digits), and press " * " or "#" button to confirm with 2
2
buzzer beeps, which indicates the acceptance and storage of the new code.
If the yellow light flashes with 3 buzzer beeps, the code changing is not
3
effective and you need to try again.
SETTING MASTER CODE
Open the safe, input "0" twice and press reset button, start setting the code
1
when the yellow light goes on.
Input the new master code (3-8 digits), then press " * " or "#" button to
2
confirm, it will be confirmed by 2 buzzer beeps and the yellow light flashes
two times, then setting the new code is done successfully.
If the yellow light flashes three times, it means the new code is
3
invalid and should be reset again.
NOTE: The user code is the code that will be used most often, the master code
can be used as a back up code. For example, if the user changes the user code,
the master code will allow the safe to be opened. Write down both codes and
keep in a safe place. You can change both master and user codes.
5
OPENING THE SAFE WITH THE EMERGENCY KEY
Upon first receipt of the safe, if keypad in not functioning, the user code is
unknown, you can use the emergency key to open the safe.
Remove the cover of the emergency lock.
1
Insert the emergency key, turn it counter clockwise, then
2
turn the knob clockwise to open the door.
Pull the handle up to open the door.
3

MOUNTING METHOD

Fix the safe in the place so it is not easy to move.
Drill holes for clamping screws in the right place.
1
Use the clamping screws to secure the case to the desired surface.
2
Make sure the case is mounted in place as required and then tighten all screws.
3
CAUTION
Place safe inside drawer. Use clamping screws to secure the safe into the drawer
or surface the safe is placed.
A
Shelf
A
Mounting Method
B
Shelf Shelf
B
6