Responding To Messages - Canon imagePROGRAF TX-4100 Guía De Configuración

Responding to Messages

Error messages may appear on the touch screen of the operation panel when setting up printer. It may not indicate a problem with the printer, and the issue may be
easily resolved. Common messages and the causes are listed here with corrective actions. For details on other messages, refer to the Online Manual.
Message
The ink tank is not installed.
Install the ink tank properly.
Print head cannot be recognized correctly.
Open the top cover and install the correct
print head.
Hardware error ECxx-xxxx (x represents a
letter or number)
Printer error has occurred.
Turn the device off, wait a while, and then
turn it on again.
Error ECxxx-xxxx (x represents a letter or
number)
Printer error has occurred.
See the manual and contact the service
center.
Cause
There is no ink tank loaded.
The ink tank is not firmly installed all the way in.
The print head is not installed.
Electrical contact failure in the print head.
The belt stopper or the tape inside the top cover
has not been removed.
You may have encountered an error that cannot
be resolved.
You may have encountered an error that cannot
be resolved.
13
Corrective Action
Install or reinstall the ink tank.
(Refer to steps 1 to 12 on p. 6 and p. 7)
Install the print head.
(Refer to steps 1 to 10 on p. 8 and p. 9)
Remove the print head, make sure that no debris becomes adhered
to the electrical contacts on the print head and the carriage, and
then reinstall the print head.
Turn off the power, open the top cover, and remove the tape and the
belt stopper, then turn the power on.
(Refer to steps 1 to 4 on p. 5)
Turn off the printer and wait at least 3 seconds before restoring the
power.
If the message appears again, write down the error code and
message, turn off the printer, and contact your Canon dealer for
assistance.
Write down the error code and message, turn off the printer, and
contact your Canon dealer for assistance.