Protecting The Environment - Black+Decker PI100LA Manual De Instrucciones

18 • ENGLISH
Caution! Most vehicle batteries are designed to provide
short period of very high current for starting the engine.
They are not designed for a constant "deep discharge".
Constantly operating the unit from a vehicle battery until
the low voltage shut off will affect the life of the battery.
If you are operating electrical products for extended
periods of time, you should consider connecting the unit to
a separate deep discharge battery.
Should a defective battery charging system cause the
battery voltage to rise to the range of 15V ~ 16VDC, the
inverter automatically shuts down; and the red LED lights
(B2C), the green LED blinks (B3).
Caution! Although the inverter incorporates
protection against over-voltage, it may still be
damaged if the input voltage exceeds 16V.
The unit will shut down automatically if the inverter exceeds
a safe operating temperature due to insufficient ventilation
or a high-temperature environment; and the red LED lights
(B2C), the green LED blinks (B3).
Battery operating time
Operating time will vary depending on the charge level of
the battery, its capacity and the power level drawn by the
particular AC load. With a typical vehicle battery and a
100-watt load, an operating time of 4 or 5 hours or more
can be expected.
When using a vehicle battery as a power source, it is strongly
recommended to start the vehicle every one hour or two to
recharge the battery before its capacity drops too low. The
inverter can operate while the engine is running, but the
normal voltage drop that occurs during starting of the engine
may trigger the inverter's low voltage shutdown feature.
Because the power inverter draws less than 0.45A with
its turning on and with no AC product connected, it has
minimal impact on battery operating times.
Interference with electronic equipment
Generally, most AC products operate with the inverter just
as they would be with household AC power. Below is the
information concerning two possible exceptions.
Buzzing and in audio systems and radios
Some stereo systems and AM-FM radios have inadequate
internal power supply filtering and "buzz" slightly when
powered by the inverter. Generally, the only solution is an
audio product with a higher quality filter.
Television interference
The inverter is shielded to minimize its interference with
TV signals. However, with weak TV signals interference
All manuals and user guides at all-guides.com
may be visible in the form of lines scrolling across the screen.
The following should minimize or eliminate the problem:
f Increase the distance between the inverter
and the TV, antenna and cables.
f Adjust the orientation of the inverter television,
antenna and cables.
f Maximize TV signal strength by using a better antenna
and use shielded antenna cable where possible.

PROTECTING THE ENVIRONMENT

Separate collection. This product must not be
disposed of with normal household waste.
Should you find one day that your BLACK+DECKER
product needs replacement, or if it is of no further
use to you, do not dispose of it with household waste.
Make this product available for separate collection.
Separate collection of used products and packaging
allows materials to be recycled and used again.
Re-use of recycled materials helps prevent
environmental pollution and reduces the demand
for raw materials. Local regulations may provide for
separate collection of electrical products from the
household, at municipal waste sites or by the
retailer when you purchase a new product.
ACCESSORIES
The performance of your tool depends on the accessory
used. BLACK+DECKER and Piranha accessories are
engineered to high quality standards and designed to
enhance the performance of your tool. By using these
accessories you will get the very best from your tool.
SPECIFICATIONS
AC Power output
AC output voltage
Maximum AC output power
Maximum AC output surge power
AC output frequency
AC output waveform
USB Power output
DC output voltage
DC Power specifications
DC input voltage range
Battery drain with no AC load
Low battery shutdown
point (nominal)
High battery shutdown
point (nominal)
Fuse
Efficiency (maximum)
PI100LA
220V (B2C)
120V (B3)
100W
200W
50-60Hz (B2C),
60Hz (B3)
Modified sine wave
5V DC
11 ~ 15V DC
≤ 0,45A
10V
15,5V
10A slip fuse
85%