Publicidad
Idiomas disponibles
Idiomas disponibles
2. Install Track and Hardware
•
Line up track flush against jamb on guide door side for 2-door, center track in opening for 4-door
(Track length should be 1/8" less than opening width)
•
Place Top pivot bracket and hangers loose in track before securing track with (#8x1") screws
•
Position top pivot bracket center 2-1/8" from jamb and hand tighten
•
Secure bottom bracket in jamb corner with (#8x3/4") screws
•
Center quick release and pivot plates on door thickness
•
Mount top and bottom pivot plates 1-3/4" from center to pivot door edge. (Fig 1)
•
Mount quick release plate 1-1/4" from center to guide door edge (Fig 2)
•
Secure plates onto door with (#8x1-1/2") screws
•
Drill 3/16" guide hole in center of guide door and secure
pull with (#8x1-3/4") screw (Fig 2)
•
To install hinges place doors side by side as if folded.
Secure with (#8x7/8") screws. (Fig 2)
3. Hang Doors
•
Fold doors together and engage top pivot
into top pivot bracket
•
Set bottom pivot assembly into the floor
2-5/8" from the wall
•
Slide carrier bolt into quick release mount
plate and close latch
4. Adjust and Finish
•
Adjust carriers and pivots so door is square
with frame
•
Slide jamb bracket carrier in or out to adjust tilt
•
Install aligners in back, about 12" from bottom
with (#8x3/4") screws. (4 door install only)
•
Install stops between top guide and side jamb
furthest from pivot for 2 door and in the middle
between the two pairs of doors for 4 doors
Publicidad
