LDI Spaces Safco 4081R Instrucciones De Montaje

an LDI Spaces Company
Minneapolis, MN 55428
www.safcoproducts.com
PRODUCT WARRANTY REGISTRATION is available online at: www.safcoproducts.com
FOOT PLATE INSTALLATION
SMALL
WASHER
SMALL
LOCK NUT
WHEEL INSTALLATION
AXLE PLATE HOLE "A"
AXLE PLATE HOLE "B"
CASTER, HANDLE INSTALLATION –
LARGE
LOCK
CASTER
If not pre-installed, insert stem of caster
through hole (as shown) then fasten
with large lock nut.
4081-37MP: 1 of 3;
Rev. 3; 8/08
HAND TRUCKS
A S S E M B L Y
FRAME
AXLE PLATE
LARGE
WASHER
LARGE
WASHER
AXLE
For handle adjustment: line up any handle
hole to frame hole. "A" is standard, "B"
is extended. Use clip to lock in desired
position. NOTE: insert clip with exposed
portion down.
available Monday-Friday 8:00 AM to 4:30 PM (Central Time) (English-speaking operators)
INSTRUCTIONS
Align holes in base of frame with square holes
in foot plate. Secure with carriage bolts, small
washers and small lock nuts as shown.
FRAME
FOOT PLATE
CARRIAGE BOLTS
FOR 10-INCH WHEELS: (Model No. 4084R and

No. 4086R) Slide axle through hole "A" in axle plates.
FOR 8-INCH WHEELS: Slide axle through hole "B"

in axle plates.
NOTE: If axle plate holes are too tight, scrape
excess paint from holes.
NEXT: Slide a large washer, a wheel (recessed side of

wheel hub facing out), and another large washer
over
each end of axle.
Insert cotter key through each axle hole and spread

COTTER
KEY
MODEL NO. 4086R AND NO. 4087R ONLY
"B"
"A"
Safco Consumer Hot Line
4081R, 4084R,
4086R, 4087R, 4092
HANDLE
PLATFORM
SUPPORT
For handle in platform position:
remove handle from frame assembly.
Reposition handle in platform supports
and insert clips.
1-800-664-0042
CLIP