Aqua Medic Blasenzahler Manual De Instrucciones página 5

Bubble counter with integrated non-return valve and a strong mounting plate. The bubble counter
can be combined with most CO
The bubble counter has to be mounted in a way that it is always without pressure. The needle valve
has to be mounted between the CO
1. Content
1. CO -inflow from the CO
2
2. CO -outflow to the aquarium/CO
2
3. Transparent counter tube
4. Screw cap PG with connections
5. Non-return valve
6. Connection fitting 1/8" 90°
7. Bubble inlet tube
8. Holding clamp
9. Holding plate
10. Rubber sucker
Available spare parts: Please refer to www.aqua-medic.de.
2. Connections
Inflow: flexible
-
transparent acrylic pipe (7), going to the bottom of the counter (1).
Outflow: flexible
-
connection fitting (2).
3. Installation
The mounting plate of the bubble counter is fixed to the wall or aquarium stand, near the CO
It can either be mounted with the rubber suckers on a glass plate (aquarium) or directly with screws
on the wall. The bubble counter is then opened carefully, filled for 1/3 with water, closed again and
carefully pressed into the holder. Take care to keep the O-ring of the plug and the top part of
the transparent counter tube dry. If these parts are wet, the counter will not be CO
If both tubes are connected to the CO
opened. Now, bubbles can be seen and counted at the bottom of the thin acrylic tube. The quantity
of the bubbles can be adjusted at the needle valve.
4. Maintenance
If the water in the bubble counter is evaporated, it has to be refilled.
-units on the market.
2
-bottle and the bubble counter.
2
-bottle
2
-reactor
2
tube, 6/4 mm diameter.
tube, 6/4 mm diameter.
-reactor and the pressure bottle, the needle valve can be
2
It is connected to
It is connected
the fitting with
to the port with
-bottle.
2
-tight.
2
the
the
5