Prestige APS-45HJ Manual Del Propietário página 13

If within 3 seconds of arming the system you press the Lock button a second time, the sensor
will be defeated for one arming cycle. If the system emits two chirps, you waited too long and
inadvertently disarmed the system.
REMOTE PANIC OPERATION
The Lock or Unlock button on your keychain transmitter also functions as a panic switch for
use in emergency situations. To use remote panic,
1. Press and hold the Lock or Unlock button on the keychain transmitter for 3 or more
seconds. The alarm will immediately sound.
2. To stop the alarm, press and hold the Lock or Unlock button on the transmitter again
for 3 seconds. If the button is not pressed, the alarm will automatically stop after
30 seconds.
ADDITIONAL REMOTE FUNCTION ( CHANNEL 3 )
This security system has an additional feature that can be connected to a number of different
optional accessories. Some of the more common uses for this channel are;
 Remote Trunk Release
 Remote Car Starter
 Remote Window Closure
To activate the optional accessory, press and hold the Trunk button on the keychain transmitter
for two seconds.
ANTI HI-JACK MODE OPERATION
1. a) With the ignition switch on, and the doors closed, press and hold the Lock & Unlock
buttons of the transmitter for 1 second to initiate the antihijack mode. The parking lights
will turn on for 1.5 seconds to indicate the mode was initiated.
b) If while the ignition is on, and a door is opened and then all doors are closed, the unit will
enter the antihijack mode. The parking lights will turn on for 1.5 seconds to indicate the
mode was initiated.
2. a) 60 seconds after initiation, the siren will begin to sound and the parking lights will begin to
flash.
b)120 seconds after initiation, the siren will start to sound, and the parking lights will begin
to flash.
3. a) 90 seconds after initiation, the starter inhibit circuit, (when installed) will be activated, the
siren and lights will continue until the battery is exhausted, or until the unit is reset.
b) 150 seconds after initiation, the starter inhibit circuit, (when installed), will be activated, the
siren and lights will continue until the battery is exhausted, or until the unit is reset.
NOTE: If you are the unfortunate victim of a vehicle Hi-Jack, for your personal safety, it is best
to leave the vehicle as quickly as possible. Never attempt to oppose the thief in any way. If the
thief prevents you from leaving the vehicle, disarm the Hi-Jack feature to prevent the system
from sounding while you are in the presence of your captor. Once you exit the vehicle, opening
and then closing the door will initiate the Hijack feature the system will go through the cycles
mentioned above. Once the engine is turned off, it cannot be restarted if the optional Starter
Inhibit Circuit is install. The unit will continue to make noise from the siren or the horn and the
lights will continue to flash until the system is reset, or until the battery is exhausted.
DISARMING THE HI-JACK FEATURE
Anytime after the Hi-Jack mode has been triggered, the circuit can be disarmed simply by
pressing the hidden push button switch. Depressing this switch one time will cause the
security system to reset the Hi-Jack mode. The circuit will not trigger again unless the door is
opened and then closed while the vehicle is running.
Page 13
128-8819
13 of 16