Kenwood DRV-410 Manual De Instrucciones página 13

Recommended installation position
• Install the device in a position where it will not block the front view of the driver (position where hidden
by the rear-view mirror).
• Install the device so that it is within the wiping range of the wiper.
• Mounting the device to the center of the windshield behind the rear-view mirror will facilitate optimal
video recording.
Outside
vehicle
Double-
sided tape
Inside
vehicle
* Fix the power cord in place with commercially available soft
tape or the like.
CAUTION
When passing the power cord through the front pillar or another part, observe the following points when
performing the wiring work.
• Wire the power cord farther forward or farther rearward than the airbag so that it does not interfere with the airbag.
• In the case of a vehicle in which the front pillar cover is fixed in place with special clips or the like, the
clips may need to be replaced after you remove the front pillar cover. For how to remove the front pillar
cover, the availability of replacement parts, and other information, contact the vehicle dealer.
• Fix the power cord in place with commercially available soft tape or the like so that it does not interfere with driving.
Windshield
Rear-view
mirror Power cord
Power cord
Ceramic part
Clip
Front pillar cover
Soft tape*
Airbag
Front pillar
9