Setting Up And Using Your Hartke; B Series Combo Bass Amplifier - Hartke B Serie Manual De Instrucciones

Setting Up and Using Your Hartke

Setting up your Hartke Systems B Series Combo Bass Amplifier is a simple procedure which takes
only a few minutes:
1. Remove all packing materials (save them in case of need for future service) and decide where
the amplifier is to be physically placed. To avoid potential overheating problems, make sure that
the rear panel is unobstructed and that there is good ventilation around the entire unit.
2. Connect the 3-pin AC plug into any grounded AC socket. Don't turn the B Series on just yet,
though.
215
B00_OM_5L_v5.indd 7

B Series Combo Bass Amplifier

3. Use a standard music instrument cable to connect your bass to
one of the Input jacks on the front panel. If your bass has passive
electronics (that is, if it has no battery), connect it to Passive Input
which is designed to handle low-voltage signals. If your bass has
active electronics (that is, if it has a battery), connect it to Active
Input, which has a 10 dB pad and is designed to handle hotter bass
pickup signals.
4. On the front panel of the B Series, turn the Volume control to its
minimum (fully counterclockwise) position, set all three EQ controls
to their "0" (12 o'clock) position, and, if you are using a B600 or B900 ,
set the Shape control to its 12 o'clock position.
5. Press the front panel Power switch in order to turn on your
B Series amp; the LED in the switch will light up.
6. Set the output of your bass to maximum and then, while playing,
slowly turn the B Series Volume control up until the desired level is
achieved. It's nearly impossible to overload the B Series amplifier, so
if you hear distortion even at low Volume settings, check for a faulty
cable (if it's good, simply back off the output of your bass).
7. If you are using a B600 or B900 , turn the Shape knob both clock-
wise and counterclockwise to hear the effect of the Shape curve
and filter on the sound of your bass. Leave the Shape knob at the
point where it best complements your particular instrument and
playing style.
8. Adjust the three equalization controls to taste (when you get a
great setting that complements your instrument and playing style,
it's a good idea to write it down for future use).
9. Test the headphone output by turning the
Volume control to its minimum (fully counter-
7 6
3/30/06 11:37:50 AM