Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Charging Instructions:
Charge the battery before using the tank for the first time or if it has been stored more than 6
months to ensure the unit is fully charged.
1.
Turn the power switch on the handle to the "OFF" position.
2.
Insert the plug (which is molded onto the end of the charger wire) into the jack, which is
located on the top left of handle.
3.
Plug the charger into 100-240 VAC 50/60 Hz volt power supply. (You may need plug adapter
if outside the U.S)
4.
While charging, the light will appear red. Light will change to green when fully charged.
Disconnect the plug from the jack and the charger from the electrical outlet.
Troubleshooting:
Pump will NOT run:
1.
Make sure the on/off switch is in the "ON" position (power switch is located on the handle
of the unit).
2.
Make sure your 12 volt battery is fully charged.
3.
Check in-line fuse on the wires on the pump (located behind back cover). If blown, replace
with new fuse (5 Amp mini-blade fuse).
4.
Ensure a tight connection at the battery clips (located behind back cover).
Pump runs, but does not prime:
1.
Inspect to make sure water is above inlet hole.
2.
Inspect hose to be sure there are no kinks or blockages.
Maintenance:
Please utilize strainer to prevent debris from getting into the pump.
Warranty
This product is warranted against defects in workmanship and materials for a period of one year
from date of shipment.
CAUTION: If storing this product in
freezing conditions, drain all of the
water to prevent damage.
Publicidad
Tabla de contenido
