Peavey PV 8 Manual De Instrucciones página 29

PV 8 Specifications
®
Frequency Response
Mic Input to Left/Right Output
Total Harmonic Distortion
<0.01% 20 Hz to 20 kHz Mic to Left/Right Output
<0.005% Typical
<0.0007% Mic Pre-amp Distortion
Hum and Noise
Output Residual Noise S/N Ratio
Master Left/Right -98 dBu
-90 dBu
-84 dBu
Monitor Send -103 dBu
-84 dBu
Effects Sends -103 dBu
-84 dBu
(Hum and noise measurements: 22 Hz to 22 kHz BW)
Equivalent Input Noise (EIN)
-129 dBu (input terminated with 150 ohms)
Crosstalk/Attenuation
Adjacent Input Channels (1 kHz) >80 dB
Left to Right Outputs (1 kHz) >75 dB
Common Mode Rejection Ratio (Mic Input)
50 dB minimum (20 Hz to 20 kHz)
70 dB typical @ 1 kHz
Meters
6 segment, peak reading (0 db = +4 dBu)
Dimensions
9.32" wide x 11.625" deep x 2.76" high
(23.70cm x 29.5cm x 7.0cm)
Installation Note:
This unit must have the following clearances from any combustible surface: top: 8", sides: 12", back: 12"
Weight
Without power supply: 5.7 lbs. (2.58 kg)
With power supply: 7.0 lbs. (3.17 kg)
14 Hz to 25 kHz +0 dB/-1 dB
(10 Hz to 80 kHz BW)
(22 Hz to 22 kHz BW)
(Ref: +4dBu)
102 dB
94 dB
90 dB
107 dB
88 dB
107 dB
88 dB
Signal/Overload Indicators
Red LED lights 3 dB below clipping
Power Requirements
PV8 Domestic: 16V AC, 1A; 8 watts nominal
PV8 USB Domestic: 15V DC, 1A, 7.5 watts nominal
15
Test Conditions
Master Fader Down, Channel Levels Down
Master Fader Nominal, Channel Levels Down
All controls nominal, mic gain minimum
All controls off
All channel sends nominal, masters nominal
All controls off
All channel sends nominal, masters nominal