Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5. Grasp the side tabs of the basket and remove it immediately
to prevent residual heating. Place it on the countertop and
remove the bottle or jar. (SEE FIGURE 6)
6. Gently swish the fluid in the bottle around or stir the food
thoroughly so the temperature becomes uniform throughout
the container.
7.
ALWAYS TEST THE TEMPERATURE OF THE FLUID OR FOOD
BEFORE FEEDING YOUR BABY.
NOTE:
The appliance is programmed to automatically reduce the time for an
additional heating cycle started within 15 minutes of the end of the previous
cycle. If you heat a second bottle immediately, you will see that time is reduced
by a pro-rated amount unless you override the feature and set a new time
yourself.
NOTE:
The appliance is equipped with an internal sensor that will automatically
shut the unit off if it gets too hot or runs out of water. The switch will
automatically reset once the unit cools down.
NOTE:
For microbiological and hygienic reasons, once milk or food is heated,
it should not be re-heated again and should be discarded if not used
immediately. Please consult your health professional for further guidance
about safety recommendations on feeding.
TO CLEAN THE APPLIANCE:
•
Always unplug the appliance and ensure it is cool before cleaning any part.
•
Remove water reservoir and empty all water out of the unit.
•
Wipe the exterior surfaces as well as the inside of the heating chamber with a
damp cloth or sponge using mild soap. DO NOT submerge the unit in any water
or liquid.
•
Removable baskets are dishwasher safe (top rack) or wash with soapy water.
Rinse with clean water. Air dry.
•
DO NOT use scouring pads, abrasives, bleach or solvents for cleaning.
•
DO NOT disassemble the product. There are no serviceable parts inside.
TO DE-SCALE THE APPLIANCE:
For best results and easiest care, it is recommended to use distilled water. It is
important to de-scale this appliance every 4 weeks to ensure that it continues to
work properly. Pour all remaining water out of the water chamber and reservoir.
To de-scale, mix 2 oz (50 ml) of white vinegar with 4 oz (100 ml) of cold water
in the water reservoir, and then run the mixture through the bottle warmer as
you normally would until any scaling has been removed. Please ensure proper
ventilation when descaling with vinegar.
8
FIGURE 6
Publicidad
Tabla de contenido
