Installation - nfortec SCUTUM X 650W Manual De Instrucciones

Installation

Installing your SCUTUM X Series
Step A: Removing your existing power supply If you are
building a new system, skip to Step B.
1. Disconnect the AC power cord from your wall outlet or UPS
and from the existing power supply.
2. Disconnect all the power cables from your video card,
motherboard and all other peripherals (SATA & MOLEX)
3. Follow the directions in your chassis manual and uninstall
your existing power supply.
4. Proceed to Step B.
Step B: Installing the SCUTUM X power supply
1. Make sure the power supply's AC power cable is not connected.
2. Follow the directions in your chassis manual and install the power
supply with the screws provided.
3. The main 24-pin power cable has a detachable 4-pin mechanism in
order to suppor t either a 24-pin or a 20-pin socket on the
motherboard.
A. If your motherboard has a 24-pin socket, you may connect the
24-pin main power cable from the power supply directly to your
motherboard.
B. If your motherboard has a 20-pin socket, you must detach the
four-pin cable from the 24-pin connector, and then plug the 20-
pin cable onto your motherboard without connecting the four-
pin connector.
4. Connect the eight-pin +12V (EPS12V) cable to the motherboard.
A. If your motherboard has an eight-pin +12V socket, connect the
eight-pin cable directly to your motherboard.
B. If your motherboard has a four-pin socket, detach the four-pin
from the eight-pin cable, and then plug this four-pin cable
directly to your motherboard.
650W / 750W / 850W 80+ Bronze
Power Supply User Manual
SATA connector Reference
Disconnect the AC power
24-pin main power cable
Eight-pin +12V (EPS12V) cable
EN
7