Publicidad
Step 13
Carefully turn your unit over onto its front edges. Lay the BACK (I) over your unit.
å
Make equal margins along all four edges of the BACK (I). Push on opposite corners of your unit if needed to make
å
it "square".
Fasten the BACK (I) to your unit using the NAILS (1N).
å
NOTE: Be sure to tap NAILS into the holes that line up over the SMALL UPRIGHT (D).
å
Fasten the BOTTOM SIDE SKIRTS (P) to the LEGS (K, L, M, and N). Use four SILVER 1-1/8" FLAT HEAD SCREWS (10S).
å
Push four CAM COVERS (12P) onto each HIDDEN CAM on the BOTTOM (F).
å
Center four SCREW COVERS (20P) over the head of each SCREW in the BOTTOM SIDE SKIRTS (P) and press fi rmly.
å
To cover HIDDEN CAMS
(4 used)
12P
M
K
20P
(4 used)
To cover screws
SILVER 1-1/8" FLAT HEAD SCREW
www.sauder.com/services
These holes must line up over
the SMALL UPRIGHT (D).
Finished edge
I
P
F
Finished edge
10S
(4 used in this step)
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
N
P
L
416955
1N
NAIL
(30 used in this step)
Page 17
Publicidad
