Charging Instructions; Bug Bag Installation; Trap Placement - Mosquito Magnet EXECUTIVE Manual De Operación

Ocultar thumbs Ver también para EXECUTIVE:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly Instructions
Trap Assembly:
Step 1
Place base upside down on a flat surface, unfold U-
shaped support leg until it locks in place.
Step 2
Turn base and leg assembly right-side-up and place
support pole into cavity on base.

Bug Bag Installation:

To insert Bug Bag, first engage front/open section then gently
push the back end down into
place.Step 4Step 4
5
NorthlineExpress.com
Step 3
Place trap power head onto pole. Press down firmly
with two hands to secure.
Assembled trap should have the front of power head/
trumpet placed farthest from the wheels in the same
direction as base U-shaped legs.
Step 4
The battery is not fully charged at the factory; charge
the battery before the first use. Under proper usage,
one charge lasts all season. See page 6 for further
details.
http://www.northlineexpress.com
Set-Up

Charging Instructions

1. Remove cover panel from rear of Power Head Unit
(panel snaps off).
2. The Battery Charger is not rated for Outdoor use. The
battery must be charged indoors.
3. Plug the Battery Charger into a suitable indoor outlet.
4. Connect the re-chargeable battery to the battery
charger.
5. The LED on the Battery Charger will indicate Red when
the battery is charging, when the battery is fully
charged the LED will indicate Green. The typical charge
time is less than two hours.
6. The battery charger is automatic, it will shut down to a
safe maintenance charge current when the battery is
fully charged. It will not over charge the battery. For
maximum life, do not leave the battery on the charger
for extended periods.
7. When the battery is fully charged, disconnect the
battery from the battery charger and return it in the
Mosquito Magnet Executive.
8. Insert and connect the re-chargeable battery.
9. Replace the cover panel on the rear of Power Head
Unit.

Trap Placement

1. Determine the direction of the prevailing wind.
Check local weather patterns if you are unsure.
2. Stand in the center of the area you are trying to protect
and look toward the prevailing wind.
3. Proper placement of the trap will be 30 – 40 feet in front
of you, within 5-6 feet of ground cover (i.e. bushes,
flowerbeds, tree line, marshbed). Ensure that trap is not
directly against any blockades such as buildings, fences, etc.
4. It is recommended that the trap be placed in the shade.
5. Do not place trap directly above a water source
(sprinklers, hose, etc.).
6. Trap must be placed on level ground to avoid tipping
or uneven propane distribution.
7. For optimal trap placement in your yard, refer to the
instructional CD-ROM included with your trap; or, go to
www.mosquitomagnet.com to build your own yard
diagram for correct trap placement.
Remove Back Panel
Insert & Connect Battery
NOTE: Make sure cover panel is replaced; trap is not
weatherproof with cover panel removed.
6
Toll-Free 1-866-667-8454

Publicidad

Tabla de contenido
loading

Tabla de contenido