Programming Options - Airzone innobus Manual De Usuario

11. TIME SCHEDULING

11.1. Programming Options

Innobus provides two types of programming options:
• P1: Set point temperature programming
The programme will apply to the zone where the Tacto thermostat is situated. The
following variables are defined:
Timeframe – Start and Finishing Time
-
Zone status – Set Point temperature or OFF.
-
The mode can be imposed and changed once made the programming.
• P2: Air-conditioning mode and set point temperature programming
The operation mode can only be programmed from the system's Master Tacto thermostat.
The following variables are defined:
Timeframe – Start and Finishing Time
-
Operation mode for the system – STOP, Cooling, Heating, Radiant Heating and
-
Combined Heating.
NOTE: In order to operate this programme we need to enable option P2 on the Master Tacto
thermostat. To enable/disable option P2, please set the status of the zone to OFF.
Press on the STOP mode icon for three seconds. Select option P2 to enable or option
P1 to disable it and confirm using the AIRZONE icon.
IMPORTANT: To impose set point temperature and operation mode at the same time, we
must perform two programs of both Set Point Temperature (P1) as the Operation
Mode (P2) separately.
11.2. How Does a Programme Work?
In order for the programmes of a zone to operate the relevant Tacto thermostat must be set
to automatic operation mode, which is represented by the
system will always be operated by the programmes stored in the relevant thermostat. Please
bear in mind that, if there is no programme set up for a specific timeframe, the system will
remain in the OFF status while in automatic mode.
In order to switch between MANUAL and AUTOMATIC modes please press the
icons and then press on the required icon.
The Tacto thermostat allows time programming (start time, finishing time and set point
temperature for that timeframe). There are up to 3 independent programmes: for each day of
the week, group of days (working days and weekends) and the full week.
Since different programmes for individual days or for groups of days can be set up, it is also
possible for programmes to overlap. When two programmes overlap, certain priorities are
established in order to determine the programme that will be activated.
All manuals and user guides at all-guides.com
icon. While in this mode the
, or
59