Before Use - Omega Lift Equipment 93200 Manual De Piezas E Instrucciones De Funcionamiento

BEFORE USE

1. Verify that the product and the application are
compatible.
2. Before using this product, read the operator's manual
completely and familiarize yourself thoroughly with
the product and the hazards associated with its
improper use.
3. Inspect before each use. Do not use if bent, broken
or cracked components are noted.
4. Ensure that all parts move freely.
WARNING
!
• Study, understand, and follow all instructions
provided before attempting to use this equipment.
• Rated capacity is per pair! Do not exceed rated
capacity.
• Use only on hard, level surfaces capable of
sustaining rated capacity loads.
• Center load between the sides of the ramp.
• Use as a matched pair to support one end of a
vehicle. One pair per vehicle only.
• Ramps are not to be used to simultaneously
support both ends or one side of a vehicle.
• Do not use other lifting equipment in conjunction
with the ramps.
• Ensure other persons are clear from the vehicle
path and the ramps.
• Never accelerate or brake suddenly. Proceed slowly
and cautiously.
• Do not disconnect brakes, engine, transmission
components, drive train, drive shaft, universal
joints, or wheels while the vehicle is on the ramps.
• No alterations shall be made to this device
• Failure to heed these markings may result in
personal injury and/or property damage.
OPERATION
Lifting
1. Center the two ramps against the tires of vehicle.
2. Ensure that the wheels to be driven on the ramps
are positioned straight forward in alignment with
the ramps.
3. After positioning the truck ramps, keep the handle
in lowest position in order to lower the base to
surface. The rubber padded base will prevent ramps
movement while vehicle is being driven onto or off
the ramps.
Note: Must keep the handle in lowest position in order
to lower the base to contact with the floor/surface.
4. Another person, standing clear from vehicle path,
should observe and guide the vehicle operator
when ascending and descending the ramps.
5. Never accelerate or apply brakes suddenly.
Proceed slowly and cautiously.
6. Once the vehicle reaches the top of the ramps,
apply brakes only to prevent over-travel.
7. Place the vehicle in neutral. Release brakes;
vehicle should not move.
8. Turn the engine off, set parking brake. Place vehicle
in park (or in reverse gear for manual transmission).
9. Get out of the vehicle and securely chock the
remaining wheels on the ground.
10 Be sure that both tires are properly positioned on
the ramp's support platform.
11 Using caution in positioning your body clear of
danger, shake vehicle sideways and endways to
be sure that vehicle and ramps are stable.
12 Check that ramps have not become damaged or
bent during loading.
Lowering
WARNING
!
Be sure all tools and personnel are clear before
lowering load.
1. Another person, standing clear from vehicle path
should observe and guide the vehicle operator.
2. Proceed slowly and cautiously, never apply brakes
suddenly.
3. After lowering the vehicle, pull the ram handle up to
dolly the truck ramp.
MAINTENANCE
Periodically inspect the Truck Ramps. To help prevent
rust, wipe clean after each use. If rust appears, sand
affected area and cover with suitable utility paint. Store
the Truck Ramps in a clean, dry area.
3