Instructions For Assembling The Fan - MIA VLO 7010 Manual De Instrucciones

I n s t r u c t i o n s f o r a s
I n s t r u c t i o n s f o r a s
Assembling the fan base
1. Release the washer and the locking screw from the pole.
2. Insert the pole through the hole in the base.
3. Turn the pole with base upside down and feed the base support weight,
followed by the washer, onto the bottom of the pole.
4. Secure the heavy weight and washer into position by fitting the
base locking screw and turning it in a clockwise direction.(Fig 1)
Attaching the fan Base to the motor unit
1. Release the motor assembly fixing screw by turning it in a anticlockwise
direction until the locking handle has been removed, then take out the set
screw.
2. Remove the tilting head set screw by twisting it in anticlockwise
direction.
3. Insert the fan support in-between the motor unit, ensure that the holes in
the motor unit align with the holes in the fan support.
4. Replace the set screw, then screw on the locking handle to secure the fan
support to the motor unit.
5. Reinsert the tilting head set screw and tighten it by turning it in a clockwise
direction.(Fig 2)
Assembling the fan head
1. Position the rear grill over the motor shaft and attached it to the motor unit
using the four rear grill locking screws.
2. Place the fan blade unit onto the motor shaft and secure it using the fan
blade screw.
3. Open the clips around the outer edge of the front grill and position it onto
the rear grill. Fasten the clips around the outer edge of the front grill to lock the
grills into position, ensuring that the fan blade and motor unit are
protected.
4. Insert the grill screw through the hole at the bottom of the front and rear
grill, then place the nut onto the grill screw and tighten it in a clockwise
direction to secure the grills together.
s e m b l i n g t h e f a n
s e m b l i n g t h e f a n
12