Mounting The Lamp; Electrical Installation - ORDISI IG-65MB Manual De Uso Y Mantenimiento

Ocultar thumbs Ver también para IG-65MB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

4. - INSTALLATION
4.1. - UNPACKING
Upon reception of the equipment, if package is seen as damaged, immediately check if device has been affected.
When device is checked and damages are confirmed, immediately refer then to the technical service for a review and be sure that
not any internal failure has happened.
4.2. - MOUNTING

4.2.1.- MOUNTING THE LAMP

For assembly of the lamp, follow these instructions:
1. Assemble the support bar No.7 with the base foot No. 12, entering the electrical cord on his inside No. 17. Hold the tubing
through the screw No. 16
2. Insert de fuse 250VF5A (No. 10) to activate emergency equipment
3. Assemble the cupola No. 3 with the arm No. 6, hold the copula through the screws No. 13, and adjust these until you can
move the copula with a gentle moving.
Fig. 2a – Base foot assembly

4.2.2. - ELECTRICAL INSTALLATION

Electrical installation of the room where you plan to use the equipment should be in accordance with the rules UNE (CIS), as well
as the Low Voltage Regulation.
The plug socket where the equipment is going to be connected, must be suitable for plugs according to standard rules UNE 20.315
and / or DIN 49.441, with terminals of 4'8 mm and lateral earthing
4.3. - TURNING ON THE LAMP
1.
Position the lamp in the most appropriate place, and immobilize, through brakes of the wheels No. 8.
2.
Connect the lamp to the mains. A red light should appear on the keypad.
3.
Turn on the lamp, using the keypad No.5, and adjust the light intensity with the + and – buttons. (See Fig. 3)
To change the position of the lamp uses the handle No. 1. Do these gently avoiding brusque movements.
4.
5.
In the event of having to move the lamp, never do it through the handle No. 1. Push it through the support bar No. 7
Fig. 3 – Keypad
.
Fig. 2b – Fork assembly
A – On / Off button
B – On / Off Led indicator
C – Luminous intensity adjustment buttons
D – Luminous intensity Leds indicators.
Página 7 de 11

Publicidad

Tabla de contenido
loading

Productos relacionados para ORDISI IG-65MB

Tabla de contenido