Troubleshooting
Before you call our Customer Care Department, go through the following troubleshooting suggestions:
EN
Problem:
The dryer won't start.
Drying cycle will not begin.
Its taking a long time to dry.
Programme finishes and
clothes are damper than
expected.
The ON/OFF light flashes to
indicate a fault.
If you still have a problem call our Customer Care Department on: 1 877 356 0766
Spare Parts
This dryer is a complex machine. Repairing it yourself or having a non-authorized person try to repair it could
cause harm to one or more persons and to the machine, and could invalidate the spare parts warranty.
Call an authorized service center if you experience problems while using the machine.
Contact number: 1 877 356 0766
service@aristonamerica.com
10
Possible causes / Solution:
The plug is not plugged into the socket, or not making contact.
There has been a power outage.
The fuse has blown.
The door is not closed securely?
The PROGRAMS knob has not been set properly (see Start and Programs).
The START button has not been pressed (see Start and Programs).
You have set a delayed time (see Start and Programs).
The filter has not been cleaned (see Maintenance).
The temperature setting is not ideal for the type of fabric you are drying
(see Start and Programs and see Laundry).
The condenser needs cleaning (see Maintenance).
The correct drying time has not been selected for the load (see Laundry).
The air intake grille or rear vents are obstructed (see Installation and see
Maintenance).
The items were too wet (see Laundry).
The dryer was overloaded (see Laundry).
! For safety the dryer has a maximum program time of 3 hours. If an
automatic program has not sensed the required final moisture in this time
the dryer will complete the program and stop. Check the above points and
run the program again, if the results are still damp, contact our Customer
Care Department.
Note down the other lights that are on and contact our Customer Care
Department.