Pinnacle MASTER MAC-121CDP Manual De Usuario E Instrucciones De Funcionamiento página 5

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Using The Blower:
1. Remove the blower from packaging. Be certain
no packaging materials are blocking the air
inlet (rear) or air outlet (front).
2. Place the blower on level ground.
3. Connect the blower to a grounded power
outlet with an approved power rating using a
14 AWG or higher gauge power cord.
4. Push the power switch on the back of the
blower to turn on the blower and to select the
desired speed.
NOTE: The direction of moving air is indicated by
an arrow on the blower housing.
Risk Of Injury! Always
WARNING
disconnect the blower from the
power source before maintenance.
DO NOT TAMPER WITH THE UNIT. HAVE
A COMPETENT SERVICEMAN MAKE ANY
NECESSARY ADJUSTMENT OR REPAIRS.
Use only original equipment parts. The use of
alternate or third party components can cause unsafe
operating conditions and will void your warranty.
TIP: To order parts call (800) 641-6996
Electrical System:
Check the power cable regularly for damage.
If the power cable is damaged, it must be re-
placed by a qualified person or a service agent.
© 2018 Pinnacle Climate Technologies, Inc.
NEVER LEAVE BLOWER UNATTENDED WHILE OPERATING OR
WHILE CONNECTED TO A POWER SOURCE
OPERATION
MAINTENANCE
4
Moisture Control:
This blower can be used to remove moisture from
an area.
NOTE: This blower will not prevent mold or
mildew formation.
Ventilation:
This blower can move large quantities of air
rapidly to provide ventilation and cooling.
RISK OF INJURY! DO NOT MOVE
WARNING
BLOWER WHILE IT IS OPERATING!
Air Outlets:
Dust and other dirt that can collect in the air outlet
must be cleaned and removed regularly.
Housing:
Clean the housing with a mild detergent and
water.
External Parts:
Check all external parts to ensure they have been
installed properly. Be alert for unusual noises.
Keep Motor And Wiring Dry:
DO NOT use a water hose or any pressurized
washing device to clean your blower. If any
electrical elements do get wet, they must be dried
immediately and completely before use.
Low Profile Carpet Dryer User's Manual

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido