involved.
• Cleaning and maintenance should not be carried
out by children unless they are at least 8 years of age and
are supervised by an adult.
• Keep the appliance and its power cord out of reach of
children under 8 years of age.
• When using electrical equipment, safety precautions
must always be taken to prevent the risk of fire, electric
shock and/or injury in the event of misuse.
• Make sure that the voltage rating on the typeplate
corresponds to your main voltage of your installation. If
this is not the case, contact the dealer and do not connect
the unit
• Never leave the unit unattended while in operation.
• Please keep this document at hand and give it to the
future owner in case of transfer of your device
• The device must not be used if it has been dropped, it
obvious signs of damage are visible or if it has leaks.
INSTALLATION INSTRUCTIONS
• Before Using Your Refrigerator
• Remove the exterior and interior packing.
• Check to be sure you have all of the following parts:
• 1 Instruction Manual
• Before connecting the refrigerator to the power source, let it stand upright for approximately
2 hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.
• Clean the interior surface with lukewarm water using a soft cloth.
• Installing Your Refrigerator
• This appliance is designed to be free standing only, and should not be recessed or built-in.
• Place your refrigerator on a floor that is strong enough to support the refrigerator when it is
fully loaded. To level your refrigerator, adjust the leveling leg at the bottom of the refrigerator.
• Allow 12 cm of space between the back and sides of the refrigerator, which allows the proper
air circulation to cool the compressor.
• Locate the refrigerator away from direct sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunlight may affect the acrylic coating and heat sources may increase electrical
consumption. Extreme cold ambient temperatures may also cause the refrigerator not to
-Save these instructions-