Operation (continued)
3
Suggested operating method
NOTE: Please ensure the connectors and endcap are all securely fastened well.
Turn the remote (C) on.
The simplest operation in RGB color mode is to make selections in this order: Choose the number of lit strips, choose the color,
choose the brightness, choose a motion, and then choose a speed.
To control how many strips are lit: Press x1 for one strip and x2 for two strips. x1 works only in RGB color mode, not WW mode.
To set the color: Select RGB for color settings. Select WW for solid white setting.
NOTE
: The WW solid white setting does not support any of the motion features of the strip. There is a white setting under RGB that
is compatible with motion settings, and to reach it choose RGB, then choose S, and then press S repeatedly until reaching the white
setting (between yellow and red).
NOTE :
8 colors, whereas 3, 7, and 16 are a combination of colors. When only one strip is used on setting 16 then only 14 of 16 colors will be
present. 2 strips must be used to see all 16 colors.
To control brightness, the strip must be in a solid color state (no motion). For solid white, press WW. For color, press RGB, and
then press S, 3, 7, or 16. Then press the up or down arrow to control brightness.
To control the speed of motion, the strip must be in a motion mode. In RGB mode, press a motion mode (example: trail, horse race,
available for WW.
At any time, it is possible to adjust settings, but brightness must be in a solid color setting to adjust, and speed must be in a
motion setting to adjust.
11
l P
a e
e s
o c
t n
c a
H
O
M
D E
1 t
8 -
7 7
5 -
7 2
0 -
1 3
f 3
r o
u f
t r
e h
a r
P E
T O
C .
O
M
s s
s i
a t
c n
. e