Descargar Imprimir esta página

Battery Installation; Charging Your Battery - Qstarz Explore 2000 Guía De Instalación Rápida

Tabla de contenido

Idiomas disponibles

English

.................................................................................................................................................................................................................................................................................................

F. Battery Installation

Put Battery in place: Use a screwdriver to unlock both screws on the battery cover. Pull

out the battery cover. Insert battery in the unit. Put weatherproof rubber on the cabinet

first and then put battery cover on it. Then push down and force it forward to fit firmly. Use

a screwdriver again to lock both screws.

G. Charging your battery

For the first time using the Explore 2000, please charge battery

until it is fully charged. Take the power cable and connect it to

the power jack (mini USB type) and recharge through USB

cable, travel charger or car cigarette adaptor. This will begin to

charge the battery. Charging time is 3 hours typically.

‐ When the Battery indicator starts to flash, battery power is in

low status. Please recharge.

‐ When the battery charge LED is on, the battery is under charging mode.

‐ When the battery charge LED is off, the battery is fully charged.

NOTE 1: During charging under off status, the device is unable to be turned on. If you wish

to use the device during charging, please turn on the device before plug in the

mini USB cable.

NOTE 2: During charging under on status, the Bluetooth is disabled. If you wish to use

Bluetooth connection, please unplug the mini USB cable.

H. Setup Explore 2000

H‐1 Install the USB Driver and software utility (Only support Microsoft Windows XP /

Vista)

www.Qstarz.com

Tabla de Contenido

Tabla de contenido