Timer Function; Cleaning And Care; Initial Use - MELINERA 288597 Instrucciones De Utilización Y De Seguridad

Protect the mains lead from sharp edges,
mechanical loads and hot surfaces.
Do not secure with sharp staples or nails.
Always unplug the mains plug from the plug
socket before installation, removal or cleaning.
Do not touch the product plug or the product
itself with wet hands.
Keep this product away from moisture.
Never electrically connect the product with
another product.
Disconnect the product from the mains when
not in use for extended periods of time (e.g.
holidays).
Do not look directly into the light, as this could
cause eye damage.
If you have any questions about the product or
are unsure about any of its aspects, please
seek the advice of an electrical equipment
specialist.
The LEDs are non-replaceable!
Installation
Unfold the lamp shade
Insert the LED bracket
4
into the lamp shade
3
Pull the cord through the cord stopper
6
to close the lamp shade
Connect the extra low voltage plug
mains adapter (see Fig. E).
2
Tighten the union nut, turning it clockwise.
Insert the mains adapter
socket.
Hang the lamp shade
using the suction cup
8
Note: Secure the cable of the light set without
damaging it. Do not secure with sharp staples
or nails.

Initial use

Switch the product on or off using the
ON/TIMER/OFF switch
Unplug the mains adapter
socket to switch off the product permanently.
(see Fig. A and B).
1
with the LED light set
(see Fig. C and D).
1
5
(see Fig. D).
1
with the
7
into the plug
2
in a suitable location
1
.
.
9
from the plug
2

Timer function

This product has a 6-hour timer with automatic
daily recurrence.
Press the switch twice to switch on the product
using the ON/TIMER/OFF switch
lights up green). After 6 hours the product will
automatically switch off and on again after
18 hours.

Cleaning and care

CAUTION! DANGER OF ELECTRIC
SHOCK! Unplug the mains plug from the plug
socket first.
CAUTION! DANGER OF ELECTRIC
SHOCK! For electrical safety reasons, never clean
the product with water or other liquids, or immerse
it in water.
Do not use solvents, petrol, etc.. Doing so
would damage the product.
Only clean it with a dry, lint-free cloth.
Disposal
The packaging is made entirely of recy-
clable materials, which you may dispose
of at local recycling facilities. The Green
Dot is not valid for Germany.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
(LED
9
GB/IE 11