to avoid pressure on the tibia when using ROM
stops. (See tibial pad adjustment section)
Strap and pad length adjustments:
If your straps and /or strap pads are too long,
you may cut them to the desired length. Cut the
strap shorter on the opposite end of the bullet tab.
Remember, straps should not restrict circulation or
cause cramping during use.
Condyle Pad Adjustment:
Attached to the hinges are the medium size pads.
Pairs of thicker and thinner pads are included. The
pads should lightly touch the medial and lateral
condyles of the knee.
Tibial Pad Adjustment:
This pad may be used if there is pressure on the
tibia. Insert the pad in between the lower calf liner
and the sub-shell component.
Maintenance:
Shells, Liners and Straps:
Regular maintenance of your brace will increase
the likelihood that the brace will remain effective
and comfortable. Before cleaning your brace, note
all location of brace parts so the components can
be easily re-attached.
Shell liners and brace pads are removable and
should be hand washed in cool water using a mild
detergent or shampoo. Do not use detergent with
bleach. Dirty liners (soap residue or salt produced
by the body) may cause skin irritation, so clean and
rinse liners very well. Air-dry the liners only as heat
will cause them to shrink.
If the brace is used in chlorinated water, rinse the
brace very well to minimize the damaging effects.
The inside of your brace shells as well as the straps
may collect residue. Rinse with water and air-dry.
The shells are painted with automotive paint and
may be cleaned and protected with automotive
products. As with any textile, your straps and liners
won't last forever. Body chemistry and frequency
of use will dictate the life of these components.
Straps and liners must be replaced to maintain
brace performance.
Hinge:
For safety reasons, the hinges should only be
disassembled by a health care professional. The
hinges should be checked regularly to ensure they
are free of foreign materials (ie. dirt or grass). You
may clean dirt from the hinges by running tap water
through them. You may also use compressed air
to blow out sand or other debris.
You may use the brace in water and get the
hinges wet, but rinse well if used in salt water
6