Label - WEG MMF-03-SP Guía De Instalación, Configuración Y Operación

application for master/slave pump or slave pump by
means of the configuration wizard, as described in
chapter 5 of the Pump Genius Multiplex application
manual. This procedure must be repeated for each pump
on the pumping system.

5 LABEL

Put up the label "Pump Genius Enabled" supplied with
the kit after installing the accessory.
This label indicates the inverter has the Pump Genius
application installed.
The label must be placed below the HMI, as shown in
Figure 1 on page
Figure 1: Location for placing the label supplied with the kit
NOTE!
Refer the "Application Configuration Files"
in the Download Center of site www.weg.
net for more details about the Pump Genius
Multiplex application.
MMF-03-SP Memory Module
7.
CFW11 | 7