SEA TORG Serie Instrucciones De Montaje Y Conexión página 6

Sistemi elettronici
di Aperture Porte e Cancelli
4. RELEASE SYSTEM
4.1. To release act as follows:
- Open the little door of the release turning it towards the right or the left side to
enter the release system (Fig. 5)
- Insert the hexagonal T-shaped key without forcing and turn it clockwise until it
stops (Fig. 6).
- Close the little door
- Open or close the leaf by hand.
4.2. To stop again act as follows:
- Open the little door of the release turning it towards the right or the left side to
enter the release system
- Insert the hexagonal T-shaped key and turn it anti-clockwise.
- Move the leaf in both directions by hand until the unit mechanism reconnects.
- Close the little door
Fig. 3
5. RACK FITTING
5.1. Release the unit and open the gate completely .
5.2. Fit the bolts to each section of rack using the provided blocking screw. Make
sure the bolts are placed in the upper part of the holes (See Fig. 7) ;
5.3. Lay the section of rack on the pinion of the operator as in Fig. 8 so that it
results parallel to the pavement guide of the gate and tack weld the central bolt B
to the gate (Fig. 9).
Manually slide the gate to set the bolt C close to the pinion and tack weld them;
repeat with bolt A.
Fig. 7
Fig. 4
Fig. 9
5.4. Repeat this method for all the pieces of rack that require to be fitted.
5.5. Check all the rack pieces are perfectly alined and placed correctely
(serrations in phases). When fitting the next section of rack use a third piece as
shown in Fig. 10 to ensure a good mesh.
5.6.Set the rack 1.5 mm higher to avoid the gate weight loading on the pinion
(Fig. 11).
Notice: Keep a gap of about 0,5 mm between pinion cog and gear rack tooth.
5.7.Slide the gate back and forth to check that the rack always stays in the middle
Fig. 5
of the pinion. If required adjust the length of the spacers.
REV 01 - 03/2005
B
A
Fig. 8
Fig. 6
C