Accessing The Control Unit Settings; Loading The Default Parameters - V2 ELETTRONICA NIUBA Manual Del Instalador De Automatización

12 - ACCESSING THE CONTROL UNIT
SETTINGS
1. Press and hold the OK key until the display shows the menu
desired
2. Release the OK key: the display will show the first item in the
sub-menu
-PrG
Programming the control unit (chapter 17)
-Cnt
Cycle counter (chapter 16)
-SEt
Auto-learning end-stop (chapter 15)
-dEF
Loading the default parameters (chapter 13)
m
WARNING: in case no operation is carried out for
more than one minute, the control unit exits from the
programming mode without saving any of your setups and
changes, which will get lost.
-PrG
2''
-Cnt
4''
-SEt
6''
-dEF
8''
- - - -
10''
13 - LOADING THE DEFAULT
PARAMETERS
If necessary, it is possible to restore all parameters to their
standard or default values (see the final summary table).
m
customised parameters.
1. Press and hold the OK key until the display shows
2. Release the OK key: the display shows
3. Press the
4. Press the OK key: the display shows
5. Press the
6. Press the OK key: all parameters are overwritten with their
d i r
tot
ESC
ESC
- 49 -
PLEASE NOTE: This procedure results in the loss of all
OK key if it is desired to exit this menu)
i
key: the display shows
i
key: the display shows
default values (see Chapter 17), the control units exits
programming mode and the display shows the control panel.
-dEF
no
Si
-dEF
ESC
(only press the
dEF
no
Si
ESC
dEF.