BEFORE FIRST TREATMENT
For detailed directions and important safety warnings, please read the
complete Instructions for Use guide before use.
HOW TO TREAT
Before every treatment, shave, clean and dry the area you wish to treat. Before
your first full treatment on any new area, perform a patch test in that area. Repeat
treatments every 2 weeks for up to 3 months or until you're satisfied with results.
1
TURN ON DEVICE
Unplug the Tria Laser Precision
from the battery charger and press
the power button.
2
UNLOCK
Unlock by holding the device tip
with the built-in skin sensor against
the skin you wish to treat. If the Tria
Laser Precision is safe for your skin
tone, the laser will emit a series
of beeps and unlock.
CHARGE: You will also need to charge the Tria Laser Precision for at
least 2 hours before you use it or anytime the battery is empty. Each
battery charge lasts approximately 15-20 minutes.
3
SET THE TREATMENT LEVEL
Press the power button to adjust
levels. For best results, treat at the
highest level that you can tolerate.
In a clinical study, higher levels were
found to be 2-3 times more effective.
4
TREAT. HOLD FOR ONE BEEP.
Touch and hold the treatment
window to the skin until you hear
a beep. Then, lift and place the laser
back on the skin so that it overlaps the
previous spot by about 1/4 inch, or 5 mm.
NOTE: It is normal for time between
beeps to lengthen as you progress
through each treatment. This should
not affect your results.