Publicidad
Idiomas disponibles
Idiomas disponibles
4. A) Attach two 1" Plastic Clips (#23) to bottom of aluminum top assembly using four Screws (#15) as
shown in FIGURE 4 and DETAIL B.
B) Attach U-Leg (#1) with two 1-1/2" Plastic Tube Brackets (#27) as shown in FIGURE 4 and
DETAIL A. Attach with twelve Screws (#15). CAUTION: Slots in Plastic Tube Brackets (#27)
must face toward middle of table exactly as shown or the table will not operate properly.
C) Attach U-Support (#3) with two 1" Plastic Tube Brackets (#24) as shown in DETAIL B. Attach with
twelve Screws (#15). CAUTION: slots in Plastic Tube Brackets (#24) must face toward middle
of table exactly as shown or the table will not operate properly.
D) Rotate U-Leg (#1) and U-Support (#3) until you see the screw hole in the slot of Tube Bracket (#27)
and (#24). Slide U-Leg and U-Support side to side if necessary to see hole. See DETAIL A & B.
E) Thread two Screws (#16) through slot in Plastic Tube brackets (#24) & into
Screws (#16) through slot in Plastic Tube Brackets
F) Slide two Plastic Leg Caps (#20) onto ends of U-Leg (#1).
Hardware Needed:
28 pcs - #15 Phillips Rd. Hd. Screw
4 pcs - #16 Phillips Rd. Hd. Screw
DETAIL A
16
15
NOTE: Tighten screws snug,
but do not overtighten, causing
screws to strip in metal tube.
Figure 4
NOTE: All Tube Bracket Slots face toward
middle of the table. As shown in Figure 4.
Tube Bracket Slots
1
27
2
(#27) & into U-Leg (#1)
Parts Needed:
1 pc - #1 U-Leg-Silver
1 pc - #2 Aluminum Top Assembly
1 pc - #3 U-Support-Silver
2 pcs - #20 Plastic Leg Cap
2 pcs - #23 1" Plastic Clip
2 pcs - #24 1'' Plastic Tube Bracket
2 pcs - #27 1-1/2" Plastic Tube Bracket
20
1
16
15
3
27
23
6
U-Support (#3)
as shown in DETAIL A & B.
DETAIL B
15
24
3
16
23
15
16
24
Middle of table is
end without stripe.
and two
Publicidad
