Metabo HPT M 3612DA Instrucciones De Seguridad Y Manual De Instrucciones página 16

English
<Using the Stopper block (Fig. 17)>
The 2 cut-depth setting screws attached to the
stopper block can be adjusted to simultaneously set
3 diff erent cutting depth. Use a wrench to tighten the
nuts so that the cut-depth setting screws do not come
loose at this time.
Screw driver
Cut depth
setting screw
Nut
Stopper block
NOTE
○ When you are not using the stopper pole to set the
cutting depth, push up the stopper pole so that it is not
in the way.
○ Please limit the cutting depth of a single cut to under
13/16" (20 mm).
2. Guiding the router
WARNING
To avoid serious accident, ensure the switch is in
the OFF position, and pull out the battery.
<Template guide>
Use the template guide when employing a template
for producing a large quantity of identically shaped
products.
As shown in Fig. 18, secure the template guide to the
base of the router with two accessory screws. At this
time, ensure that the projection side of the template
guide is facing the bottom surface of the base of the
router.
Template guide
Projection
Screw
16
Fig. 17
Fig. 18
A template is a profi ling mold made of plywood or
thin lumber. When making a template, pay particular
attention to the matters described below and
illustrated in Fig. 19.
When using the router along the interior plane of
the template, the dimensions of the fi nished product
will be less than the dimensions of the template by
an amount equal to dimension "A", the diff erence
between the radius of the template guide and the
radius of the bit. The reverse is true when using the
router along the exterior of the template.
Template guide
Secure the template to the workpiece. Feed the router
in the manner that the template guide moves along
the template as shown in Fig. 20.
<Template guide adaptor (Fig. 21, Table 8)>
Use of the template guide adapter is required when
using the template guides produced by other fi rms
with a portion of the standard accessories. The
template guide adaptor, like the template guide, is
attached to the base with two accessory screws.
Attach template guides made by other fi rms to the
template guide adaptor.
Template guide
Template guide
adaptor
Template guide
Bit
Template
A
Fig. 19
Fig. 20
Template
guide
Fig. 21