Braun Syncro System Smart Logic 7526 Manual Del Usuario página 11

Before using Clean&Renew™
For the first charge of the shaver, connect the power
supply cord set directly to the shaver, charge it for
4 hours and shave at least once.
Only then can the shaver be cleaned or recharged in the
Clean&Renew™.
If the rechargeable batteries are discharged, select the
combined «clean + charge» program rather than the
«clean» program alone.
Installing the cartridge
Press the lift button (12) to open the housing.
Hold the cartridge down on a flat, stable surface
(e.g. table). Carefully remove the lid from the cartridge.
Slide the cartridge into the base as far as it will go.
Slowly close the housing by pushing it down until it
locks.
Replacing the cartridge
After having pressed the lift button to open the housing,
wait for a few seconds before removing the used car-
tridge.
Before discarding the used cartridge, make sure to
close the openings using the lid of the new cartridge,
since the used cartridge will contain contaminated
cleaning solution.
Operating your Clean&Renew™
• Use the power supply cord set from your shaver and
plug it into the Clean&Renew™ and then into a main
outlet.
Open the contact bow (13) by pressing the release
button (14). After shaving, switch the shaver off and
place it upside down into the Clean&Renew™
(without having released the shaver foil).
• Select the operation mode by toggling with the
mode selector (15):
clean
clean + charge
charge
The corresponding lights will come on.
(With cord shavers, only the «clean» function can be
selected.)
(about 15 min)
(about 75 min)
(about 60 min)
1
new
old
new
11