Service Adjustments; Carburetor - Sears 919.329110 Manual Del Propietário

Clean Guard/Muffler
Do not clean with a forceful spray of water because
water could contaminate fuel system. With a brush or
cloth clean finger guard after every use to prevent
engine damage caused by overheating. Before running
engine, clean muffler area to remove all combustible
debris.
CLEAN

CARBURETOR

The carburetor of your generator is pre-set at the fac-
tory. The carburetor should not be tampered with. If your
generator is used at an altitude in excess of 4000 feet
performance may be affected. If so consult with your
nearest Sears Service Center regarding high altitude set
changes.
GOVERNOR
Your engine governor maintains the constant operating
speed of your generator. DO NOT tamper with the en-
gine governor which is factory set for proper engine
speed.
D20508
CLEAN

SERVICE ADJUSTMENTS

16 — ENG
Clean and Replace Spark Plug
Check spark plug yearly or every 100 operating hours.
• Clean area around spark plug.
• Remove and inspect spark plug.
• Replace spark plug if electrodes are pitted, burned
or porcelain is cracked. For replacement use
Champion RJ17LM resistor spark plug.
• Check electrode gap with wire feeler gauge and
set gap .030 if necessary.
• Install spark, tighten securely.
.030" (0.76MM)
WIRE GAUGE
SPARK PLUG
Over-speeding your engine above factory high speed set-
ting can be dangerous and could possibly cause per-
sonal injury or property damage. If you believe the en-
gine is running too fast or slow, take your generator to a
Authorized Sears Service Center for repair and adjust-
ment.
Low engine speeds impose a
heavy load on the engine and
when sufficient power is not available the engine
life could be shortened.