Thulos TH-HW11 Manual De Instrucciones página 7

HOW TO HOLD YOUR SEWING MACHINE (Fig. K):
Hold the machine in your right hand by placing your thumb on the top of the machine.
Place the other fingers at the bottom.
HOW TO SEW (Fig. L & M):
 Raise up the fabric clamp, place the fabric to be machined between the fabric
clamp and the needle plate and lower the fabric clamp (Fig. L). During the sewing,
the fabric will be transported to the left. This is why it must be placed into the
sewing machine at the left end.
 Pull the threaded yarn out around 5cm.
 Turn the handwheel until the needle pricks into the fabric. Hold the fabric firmly
with your left hand.
 Take the sewing machine in your right hand and slide the On/Off switch into the
'On' position using your thumb.
 The fabric is sewn and transported to the left (Fig. M). Guide the fabric carefully
with your left hand so that the stitch is straight. To extend the length of the
stitches, you can pull the fabric lightly and evenly.
HOW TO CHANGE THE SEWING DIRECTION:
 Stop the sewing machine at the point where you want to change the sewing
direction and so that the needle is positioned in the fabric. If necessary, turn the
handweel until the needle pricks into the fabric.
 Raise the fabric clamp and turn the fabric to face the new direction, using the
needle as the fulcrum.
 Lower the fabric clamp and continue sewing in the new direction.
HOW TO END THE SEWING (Fig. N & O):
 Stop the sewing machine.
 Turn the handwheel to bring the needle up to its highest position.
 Use a pair of scissors to pull some more thread out of the sewing machine (Fig.
N). Cut through the thread approx. 15cm from the fabric so that enough thread is
left over to secure the seam by hand.
 Raise the fabric clamp and carefully pull out the fabric (Fig. O).
HOW TO CHANGE THE NEEDLE (Fig. P):
 Take the batteries out of the device before replacing the needle.
 Bring the needle up to its highest position with the handwheel.
 Hold the needle and loosen the needle clamp screw by turning it in the
anticlockwise direction. You can now remove the needle.