Power Sources; Ac Operation; Battery Installation; Care And Maintenance - LEXIBOOK SPIDER-MAN RCD10SP Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
The Spider-Man CD Boombox operates on AC 230V – 50Hz or with 8 x C size
included).

AC operation

1. Check that the unit is switched off.
2. Insert the small end of the AC cord into the AC socket at the back of the unit.
3. Plug the other end of the AC cord into any convenient AC 230V – 50Hz power outlet.

Battery installation

1. To install the batteries, open the battery compartment located at the back of the unit by pressing in
on the tabs, then lifting it off.
2. Insert 8 x C size batteries (not included) observing the polarity indicated in the compartment, and as
per the diagram shown below.
3. Close the battery compartment.
Note: The AC power cord must be disconnected from the AC socket on the rear of the unit in order for
the product to operate on battery power.
WARNING: If the unit malfunctions or receives an electrostatic shock, turn the unit off and on again. If
this proves to be ineffective, remove the batteries and insert them again.
Non-rechargeable batteries are not to be recharged. Rechargeable batteries are to be removed
from the toy before being charged. Rechargeable batteries are only to be charged under adult
supervision. Different types of batteries or new and used batteries are not to be mixed. Only
batteries of the same or equivalent type as recommended are to be used. Batteries are to be
inserted with the correct polarity. Exhausted batteries are to be removed from the toy. The supply
terminals are not to be short circuited. Do not throw batteries into a fire. Remove the batteries if
you are not going to use the game for a long period of time.

Caring for discs

• Treat the disc carefully. Handle the disc only by its edges. Never allow your fingers to come in
contact with the shiny, unprinted side of the disc.
• Do not attach adhesive tape, stickers, etc. to the disc label.
• Clean the disc periodically with a soft, lint-free, dry cloth. Never use detergents or abrasive cleaners
to clean the disc. If necessary, use a CD cleaning kit.
• If a disc skips or gets stuck on a section of the disc, it is probably dirty or damaged (scratched).
1
RCD10SPIM0088.indd 14

POWER SOURCES

CARE AND MAINTENANCE

batteries (not
26/2/08 15:32:42

Publicidad

Tabla de contenido
loading

Tabla de contenido