Heating Mode; Cleaning And Maintenance - Vava VA-EE009 Manual Del Usuario

Specif ications
Model VA-EE009
Input US / CA: AC 120V 60Hz
EU / UK: AC 220V - 240V 50Hz
Power 550W
300 ml / 10.1 oz Max
Capacity
Cable Length ≥0.7m / 27.6 in
Working Time 5.5 minutes max
How to Use
Whisk Function
Whisk (Frothing) Frothing cold milk
Frothing & Heating
Whisk (Heating) Heating
(with a small amount of froth)
Frothing Mode
MAX
MAX
MIN
1. Install the frothing whisk onto 2. Press the Power Button to
the whisk. Add an appropriate start heating and frothing
amount of milk into the pitcher milk, the indicator will turn
no higher than the MAX frothing red when working and flash
level, cap on the lid. Connect to when the process is
a power source. The product is completed.
now in standby mode.
Note:
Milk will warm up once frothed.
Capacity Working Time
150 ml / 5.1 oz 2 minutes
150 ml / 5.1 oz 4.5 minutes max
300 ml / 10.1 oz 5.5 minutes max
3. Press and hold the Power
Button for 2 seconds to
activate milk frothing mode,
the indicator will turn blue
when frothing and flash when
frothing is finished.

Heating Mode

MAX
MAX
MIN
1. Remove the frothing whisk, add an appropriate
amount of milk into the pitcher no higher than
the MAX heating level. Bring the device into
standby mode the same way as in frothing mode.
Note:
There will be a small amount of frothing once the milk is heated.
Note:
1. Use whole milk (fat content > 3.0%) for the best results.
2. The frother can heat milk up to 65℃ - 70℃ / 149 ℉ - 158℉.

Cleaning and Maintenance

Always disconnect the appliance from power after use and before cleaning.
1. Never immerse the power base and cord in water or expose them to moisture.
2. Clean the pitcher in a dishwasher or wipe it with a damp cloth, do not use abrasive cleaner.
3. To clean the lid, remove it from the pitcher and clean in a dishwasher or under tap water.
4. Rinse the whisk with clean water and wipe it dry, store it in a safe place.
2. Press the Power Button to start heating and
whisking milk. The indicator will turn red when
working and flash when the process is completed
02/03