Triton Multi-Stand MSA200 Instrucciones De Uso Y De Seguridad página 7

Folding and Unfolding
• The Triton Multi-Stand quickly and easily folds for convenient storage, (Image I):
1. Loosen the Height Adjustment Clamping Screw (6)
2. Slide the Column (5) in as far as it goes, and tighten the Height Adjustment Clamping
Screw
3. Loosen the Tilt Head Clamping Screw (4), tilt the Tilt Head (1) into the vertical position
4. Fold in all three Tripod Legs (8)
Note: To unfold the Triton Multi-Stand, follow the above steps in reverse order.
Operation
Positioning and Adjusting
WARNING: Always use theTriton Multi-Stand in a stable position. If the ground is uneven or
sloping, the stand must be secured to the ground by using suitable fasteners, such as screws,
nails or pegs, through the holes in the Rubber Coated Feet (7).
• The Triton Multi-Stand features a Tilt Head (1) that can be adjusted horizontally (0°),
vertically (90°), or in any angle between 0 and 90°:
1. Loosen the Tilt Head Clamping Screw (4)
2. Adjust the Tilt Head (1) into the required position
3. Tighten the Tilt Head Clamping Screw
Clamping
• The inside surface of the Tilt Head (1) features an adjustable serrated clamp that can be
used to hold a workpiece:
1. Loosen the Workpiece Clamping Screw (3) to adjust the serrated clamp, so it fits the
workpiece
2. Insert the work piece into the Head Channel (9) and close the Workpiece Clamping Screw
tightly (Image II)
WARNING: The serrated clamp may leave an imprint on the workpiece when clamping. Use
a shim or thin spacer between the serrated clamp and the workpiece, to keep it in pristine
condition.
Use as Sliding Work Support
• TheTriton Multi-Stand can be used as an infeed or outfeed support, sliding the workpiece
over the horizontal low-friction surface of the Tilt Head (1)
• Where additional height is needed, clamp an object with smooth surface, e.g. a piece of
wood, into the Tilt Head (as described in 'Clamping'), to extend the height of the Triton
Multi-Stand, (Image III)
Building Work Supports
• Two or more Triton Multi-Stands can be used to build a variety of customised work
supports, (Image IV)
Accessories
• Visit www.tritontools.com to see the full range of Triton work supports and precision
power tools
Maintenance
• Inspect the Triton Multi-Stand before every use. DO NOT use if any kind of damage is
detected (deformation, corrosion, damaged welds etc.). The device may not be fit for
service and needs to be inspected by a qualified Triton technician
• Clean the body of the Triton Multi-Stand with a soft brush or dry cloth
• If the Triton Multi-Stand has become wet, dry thoroughly before storage
• From time to time, or after contact with water, the clamping screws, column and tilting
mechanism should be lightly lubricated with a suitable maintenance spray
Storage
GB
• Store the Triton Multi-Stand carefully in a secure, dry place out of the reach of children
6
MSA200_Z1MANPRO1_US.indd 6 16/11/2015 10:32