Connections - Hiltron l'originale PROTEC5X Manual Para El Usuario

PROTEC5X - User's manual
When the installation is finished, it needs to connect the red/black conductors equipped
with faston coming from the AL5 power supplier to the battery. Be careful about connection
polarity (Red=positive [+] of the battery; Black=negative [-] of the battery), so that no cause
great damages to the connected devices.
ATTENTION!
The 12V7Ah battery must always be connected. Ensure of its efficient charge state,
measuring the tension by a volt-meter, after disconnecting the main power supply from
the AL5 power supplier/battery charger by the sectioning switch. Also in case of
changing of the lead battery it's necessary to disconnect the main power supply from
the AL5 power supplier/battery charger, to avoid that the entire system burden on it.
Don't connect on 13Vcc services power supply output of the central unit (clamps [1] and
[2] "+12V") a load beyond 650mA.
After connecting the central unit and the siren batteries, it's possible to power on the
system by the sectioning switch connected on the AL5 power supply/battery charger main
power clamps. The "RETE" LED signals the effective presence of the main voltage.
The PROTEC5X and the AL5 don't need the ground connection, but for safety reasons
and for the respect of the laws in vigor we suggest to make and test the ground connections of
the all devices that need it.
2.3

Connections

1 - 2 13Vcc regular output tension for volumetric detectors, telephone dialer, etc.
ATTENTION! Maximun current supplied: 650mA
1 - 3 13Vcc output tension on system enabled for the telephone dialer enabling.
4 - 5 - 6 - 7 Output for m
SK key.
8 - 12 24h protection zone NC* line (immediated).
9 - 12 Zone 1 NC* line (d
10 - 12 Zone 2 NC* line (immediated).
11 - 12 Zone 3 NC* line (immediated).
13 - 14 13Vcc output tension in alarm condition for supplementary indoor sirens and
telephone dialer activation.
13 - 15 13Vcc output tension to recharge the autopowered siren. In alarm condition
this tension falls.
* If the alarm zones are not used, the clamps must be arched.
30
1 2 3 4
aximum 3 supplementary SKI/M - /L - /NL connectors for electronic
elayed).
5 6 7 8 9 10 11 12 13 14 15