Daitsu DS-9KIDB Manual Del Usuario página 13

Introduction for buttons on remote controller
5
Swing button
Press this button to set up & down swing angle.
6
Sleep button
Under Cool or Heat mode, press this button to turn on Sleep function. Press this
button again to cancel Sleep function. Under Fan、Dry and Auto modes, this
function is unavailable.
7
Temp button
Press this button, you can see indoor set temperature, indoor ambient temperature
on indoor unit's display. The setting on remote controller is selected circularly as below:
Note:
● Outdoor temperature display is not available for some models. At that time, indoor
unit receives "
8
Turbo button
Press this button to activate / deactivate the Turbo function Under COOL or HEAT mode.
9
I Feel button
Press this button to start I FEEL function and "
controller. After this function is set, the remote controller will send the detected
ambient temperature to the controller and the unit will automatically adjust the
indoor temperature according to the detected temperature. Press this button again
to close I FEEL function and "
● When I FEEL function is turned on, the remote controller should be put within the
area where indoor unit can receive the signal sent by the remote controller.
10
Timer button
● Under ON status, press this button to set timer OFF; Under OFF status, press
this button to set timer ON.
● Press this button once and the characters of HOUR ON (OFF) will flash to be
displayed. Meanwhile, press " " button or " " button to adjust timer setting (time
will change quickly if holding " " or " " button). Time setting range is 0.5~24hours.
Press this button again to confirm timer setting and the characters of HOUR ON
(OFF)will stop flashing.
If the characters are flashing but you haven't press timer button,timer setting
status will be quit after 5s.If timer is confirmer, press this button again to cancel
timer.
11
WiFi button
Press " WiFi " button to turn on or turn off WiFi function. When WiFi function is
turned on, the " WiFi " icon will be displayed on remote controller; Under status
of unit off, press "MODE" and " WiFi " buttons simultaneously for 1s, WiFi module
will restore to factory default setting.
● This function is only available for some models.
no display
" signal, while it displays indoor set temperature.
" will disappear.
▲
▲
" will be displayed on the remote
10