Midas VeniceU Guía De Arranque Rápido página 15

The installation will begin.
6. During the installation procedure the following dialog box will appear.
Plug the USB cable into the VeniceU console (type B connector) and into
your PC (type A connector). Then switch on the console and click OK in the
dialog box.
7. The installation procedure should continue. After the installation has been
completed successfully, click Next.
8. In the "Completing ..." screen of the Setup dialog box, click Finish.
9. The Archwave icon should appear in the task bar at the lower-right
corner of the screen.
You are now ready to use USB with the VeniceU console. For example, use the
REASON software application to record a performance or to do a virtual
sound check.
The default settings of the USB software you have just installed should be
adequate for use. However, if you want to change these settings, open the
Archwave USB Driver Control Panel by clicking on the Archwave icon
(shown above).
If you encounter unwanted audio artefacts, such as humming, this is probably an
indication of ground loop problems—refer to the Operator Manual for details.
mac operating system
USB, when used with a Mac running OS® X (version 10.7 or later), is a 'plug and
play' device. So, unlike on a PC running Windows® 7, there is no need to install
a USB device driver. Also, this Mac version has its own interface for using the
supplied third party recording software.
The default settings of the Mac's USB device driver should be adequate for use.
However, you can change these settings via the Audio panel in Reason. To open
the Audio panel, choose Preferences > Audio in the Reason menu.
If you encounter unwanted audio artefacts, such as humming, this is probably an
indication of ground loop problems—refer to the Operator Manual for details.
Operator Manual 15
midasconsoles.com