Remote Control, Without Remote Control - TUV Rheinland ITC1510 Instrucciones De Instalación Y Funcionamiento

Push the tab in the direction of the arrow as shown in Fig. 1 below and move the lid upwards at the
s ame time. Remove the battery from its housing and replace it with a new one. Before using the
remote control, remove the transparent safety label shown in the figure.
Note : When the timer of the appliance is active, the point on the right of the screen flashes. 1L ,
2L ...: Indicates the power level of the heater.
1H, 2H ...: Heater timer display (May be programmed up to 9 hours. )
Er1: Overheating.
Without Remote Control
Function Key : Controls the temperature level setting and the timer setting of the heater.
Temperature level shall be increased one level for each press on the key. Keep this key pressed
seconds to perform a timer setting. Select the desired time zone from the menu displayed on the
for 6
Appliance Stand-by
screen.
displayed on the screen.
This key is used for switching the appliance on and off.
Used increasing the level, temperature and timer settings.
Used decreasing the level, temperature and timer settings.
Heater level setting: Heater switches to power control mode.
Allows level setting between 3 levels using the + and - keys.
Displays L1, L2, L3 by signalling for 0.2 seconds at each step. If
the heater is in power control mode, appliance operates at
maximum level when the max button is pressed.
Thermostat switch: Switches to temperature setting mode.
Performs temperature setting from 10 to 40 degrees with the + and
- keys. Press mode button to save the set temperature. User is
required to press this button once only to see the set temperature.
Signals for 0.3 seconds at each step.
Timer key: Switches to timer mode by flashing on the display, and
timing may be set up to 9 hours with the + and - keys. Press this
key again to save the timing after setting it. User is required to press
this button once only to see the remaining time. 1H, 9H are
displayed on the screen.
: Indicates that the appliance is ready for operation when this symbol is
11