Yokis MTV500ER Manual Del Usuario página 8

RADIO: MTV500ER -
500W Timed Dimmer Module
with neutral - Code 5454454
Functions
This module is used to vary the brightness of a light with radio control.
Technical specifications
- Mains voltage:
- Minimum power:
- Maximum power:
- Allowed loads:
- Radio frequency:
- Ambient temperature:
- Relative humidity:
- Dimming:
- Protections:
- Dimensions:
Wiring
Installation on remote controlled sockets is risky because end users could connect any type of electrical load and
CAUTION
Accessory FDVDT (Code 5454075) must be installed if the power line of the module is shared with inductive loads
(e.g. window shutters or ferromagnetic ballasts or ferromagnetic transformers). The accessory must be connected as close
as possible to the module in parallel between live and neutral. The internal overvoltage protection of the module could be
rapidly damaged without this accessory.
Dimmer wiring with neutral
230V~ 50Hz
Optional
Load
button
Blue wire
Orange
wire
(*) Contact an Urmet retailer or go to www.yokis.com for information on availability
DS1054-011D
230 V ~ (+10% -15%) - 50 Hz
5 W
500 W 2 A, in normal installations
250 W 1 A, in installations in IP65
sealed boxes
Please refer to the provided booklet
DS1054-022
2.4 GHz
from -20°C to +40°C
from 0 to 90%
on sinusoidal at start or end of phase
with automatic load type detection
short-circuit and overheating
protections
46 x 37 x 12 mm
[1.81 x 1.46 x 0.47"]
DO NOT INSTALL ON REMOTE CONTROLLED SOCKETS
damage the module as a consequence.
The module must be installed only by qualified personnel and into a
place the end-user cannot access, according to the installing natio-
nal rules.
In order to follow the safety rules, the module must be connected to
a power line that is upstream protected by a magnetothermic switch
10A C curve.
With the low voltage light bulbs do not mix the ferromagnetic, electronic
Red wire
and toroidal transformers.
Aerial
Hold the pushbutton pressed with the light on to dim it and store the setting. The
setting will be stored when the pushbutton is released. Press again to reverse
the dimming (up-down or down-up).
Press once to turn the light on or off at the stored brightness. Press twice to set
to 100% brightness. The two functions may be reversed.
Press three times to set brightness to 50% and four times to set brightness to
minimum level (adjustable).
This is outlined in the following table:
N. of presses
Radio range
Standard range:
• In the same room (< 100 m²)
• 50 m in open range
POWER range (*):
• inside 100 m² apartments with perpendicular crossing
of main wall or ceiling
• 250 m in open range
(Note: in both cases the range may be reduced by presence
of metallic elements, crossing of walls or partitions)
Radio transmission
The transmitter LED will light up only if radio
transmission was successful.
Adding an intermediate receiver makes it possible to
solve a problem of insufficient range.
Refer to the transmitter instruction booklet for more
information.
Installing Cautions
Preset dimmer settings
Memory mode
1 Stored setting
2 100%
3 50%
4 Minimum level
6 100% for 12h
7 Child night light mode
P8
GB
Operation
Stored setting
Minimum level
Child night light mode
100% mode
100%
50%
100% for 12h