Safety Guidelines - Definitions - Porter Cable PC75TRS Manual De Instrucciones

Your risk from these exposures varies, depending on how often you do this type of
work. To reduce your exposure to these chemicals: work in a well ventilated area, and
work with approved safety equipment, such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with dust from power sanding, sawing, grinding, drilling,
and other construction activities. Wear protective clothing and wash exposed
areas with soap and water. Allowing dust to get into your mouth, eyes, or lay on the
skin may promote absorption of harmful chemicals.
cause serious and permanent respiratory or other injury. Always use
WARNING:
NIOSH/OSHA approved respiratory protection appropriate for the dust exposure. Direct
particles away from face and body.
ANSI S12.6 (S3.19) during use. Under some conditions and duration of use, noise
WARNING:
from this product may contribute to hearing loss.
by the operating action of this tool may cause permanent injury to fingers, hands,
WARNING:
and arms. Use gloves to provide extra cushion, take frequent rest periods, and limit
daily time of use.

SAFETY GUIDELINES - DEFINITIONS

It is important for you to read and understand this manual. The information it contains
relates to protecting YOUR SAFETY and PREVENTING PROBLEMS. The symbols
below are used to help you recognize this information.
Indicates an imminently hazardous situation which, if not avoided, will
result in death or serious injury.
DANGER:
result in death or serious injury.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, may
result in minor or moderate injury.
CAUTION:
Used without the safety alert symbol indicates a potentially hazardous
situation which, if not avoided, may result in property damage.
CAUTION:
SYMBOLS
• The label on your tool may include the following symbols. The symbols and their
definitions are as follows:
V..................volts
Hz................hertz
min ..............minutes
............direct current
................Class I Construction
(grounded)
................Class II Construction
(double insulated)
MOTOR
Be sure your power supply agrees with nameplate marking. 120 Volts AC only means
your tool will operate on standard 60 Hz household power. Do not operate AC tools on
DC. A rating of 120 volts AC/DC means that your tool will operate on standard 60 Hz AC
or DC power. This information is printed on the nameplate. Lower voltage will cause loss
of power and can result in over-heating. All Porter Cable tools are factory-tested; if this
tool does not operate, check the power supply.
Use of this tool can generate and/or disperse dust, which may
Always wear proper personal hearing protection that conforms to
Do not operate this tool for long periods of time. Vibration caused
Indicates a potentially hazardous situation which, if not avoided, could
A ..................amperes
W..................watts
................alternating current
n o ................no load speed
..................earthing terminal
................safety alert symbol
.../min ..........revolutions or reciprocation
per minute
4