Publicidad
Idiomas disponibles
Idiomas disponibles
QUICK PROGRAMMING GUIDE 912-TT DVB-S/S2 TO DVB-T
Start/on
Main menu
Transcodifi cador 912 QPSK - COFDM
Select series
NIT table
Select series
912-TT Transmodulator DVB-S/S2 to DVB-T
912-MS Modulators
912-TT Transmodulator DVB-S/S2 to DVB-T
Confi gure module
Set the programming switch of the 912-TT module to the ON position. The programming
Input
Power LNB
off
off
off
on
Input frequency
1952
Symbol rate
Auto
Standard
DVB-S2
Modulation
QPSK
Roll off
0.35
FEC
Auto
Input level
BER
Output
Standard
DVB-T
DVB-T
DVB-H
Program by
Channel
Channel
Frequency
Channel table
BG CCIR
Channel
21
indicator will now light up and remain lit.
OK++OK+T
MHz
Keypad + T
Keypad + T
1000
KBd
OK++OK+T
OK++OK+T
OK++OK+T
OK++OK+T
65
dBuV
< 1E-7
OK++OK+T
OK++OK+T
OK++OK+T
Keypad + T
OK++OK+T
Press the Power On key of the PS-011 to start up the
system.
Choose Select Series to select the programming series.
OK
Select the series: 912-TT Transmodulator DVB-S/S2 to
OK
DVB-T.
To commence programming the module, select Confi gure
OK
module.
Select LNB power on/off. Then press T to transmit.
Using the numeric keypad, enter the FI frequency of the
transponder. Then press T to transmit.
Enter the input frequency of the transponder using
the numeric keypad. Then press T to transmit.
Enter the symbol rate of the transponder using the
numeric keypad. Then press T to transmit.
Select the standard DVB-S/DVB-S2. By default it is
set to Auto. Then press T to transmit.
Select the modulation QPSK/8PSK. By default it is set
to Auto. Then press T to transmit.
Select the roll off. Then press T to transmit.
Select the forward error correction rate (FEC) of the
transponder. By default it is set to Auto. Then press T to
transmit.
When the input transponder data have been entered,
press the READ key to obtain a reading of the input
READ
signal.
Select the COFDM modulation standard. Then press T
to transmit.
Select the programming mode for the output of the
module: channel or frequency. Then press T to transmit.
Select the standard for the output channel. Then press
T to transmit.
If the output is programmed by channel, it is possible to
enter the channel using the numeric keypad. Alternatively,
o
you can select a channel from the pull-down list. When
you have confi rmed your choice by pressing OK, press
T to transmit.
ENG
Publicidad
