Operation - Glace Bay FW6A0018CP Guía De Instalación Y Cuidado

Operation

1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the
aerator to the flush the water lines. Do not lose the
gasket in the aerator.
□
Ensuring the handles are in the off
position, turn on the water supply and
check for leaks. If you discover any leaks,
check your connections to ensure they
are installed properly.
□
Use the aerator wrench (P) to remove the
aerator (F) and housing (if applicable).
Turn on the hot and cold handles to allow
the water to run for at least one minute.
This flushes away any debris that could
cause damage to internal parts.
□
Turn off the water and reinstall the
aerator and housing (if applicable).
2
Removing the quick connector
CAUTION: Use caution when removing the quick
connecting hose connections in order to prevent cutting
your hands.
□
If it is necessary to remove the quick
connector, push the quick connecting
hose (J) up, hold the housing together
and pull down.
F
P
1
7
Please contact 1-855-HD-GLACIER for further assistance.
2
3
J
HOMEDEPOT.COM/GLACIERBAY