Charging The Batteries - VIETA VHP-WJ500 Manual De Usuario

Pairing:
If the headphone remains not working after
following the operation processes above, start
pairing process by pressing the power button for
12 seconds in the dongle in shutdown state. After
that, pressing the headphone pair button until the
blue LEDs flash. The LEDs will change to solid
blue when pairing process is finished.
Note:
In order to protect the dongle and save power,
the dongle will automatically switch to stand-by
mode (LED will turn off) after approximately 2
minutes if there is no audio signal, or the signal
that it receives from the audio source is too weak
for proper reception. If however the signal returns
to an acceptable level, then the transmitter will
automatically switch back on. The dongle will
automatically shut off if stand-by mode last for
more than 15 minutes.
The headphone receiver will automatically shut off
if getting no signal from transmitter in 15 minutes.
All manuals and user guides at all-guides.com

CHARGING THE BATTERIES

• Switch OFF both the dongle and headphone.
• Apply the charging cable one end with 2 charging
• Charging can be processed by connecting with
• Charging dongle and headphone can be
• Be sure to charge new batteries for 5 hours
Warnings:
** The battery pack must be fully charged before
first use. An initial 5 hours charge is required
to guarantee an acceptable service life for the
rechargeable batteries. Always ensure that the
dongle and the headphones are switched to the Off
position while the batteries are charging.
ports and the other with USB.
PC or with power adapter.
processed simultaneously.
before using them for the first time in the dongle
and headphone. The red indicator light (LED) will
be on continuously during battery charging.
9