NINCOAIR ALU3 180 Manual Del Usuario página 7

On / Off indicator LED
Up / down
Trim
INSTALLATION AND BATTERY CHARGE
Transmitter:
Switch in position OFF
1. Open the battery cover.
2. Fit the batteries (respect polarity).
3. Close battery cover.
BATTERY HELICOPTER CHARGE
Switch in position OFF.
1. Open the charger cable cover.
2. Connect the cable to the helicopter.
3. Turn the switch of the transmitter in (ON) position.
4. Red LED will turn on. When the process finishes the LED will turn
off. (Charging time approx. 30-40 min).
5. Disconnect the plug. The flying time is 5-7 min..
HELICOPTER FLIGHT
1. Select the band in the transmitter A, B o C and the helicopter will automatically identify it.
2. With the helicopter switched off, first switch on the transmitter.
3. Switch on the helicopter.
4. Place the helicopter in the floor.
5. Synchronizing transmitter and helicopter: Full push the left stick for a second.
TRIM ADJUSTAMNETS
Trim adjustments:
1. Push again the left stick SLOWLY to start the flight (approx. between 0,5m and 1m).
2. If the tail turns left or right, please trim it using the trim button on the transmitter. Turn it clockwise o vice versa until the helicopter stops
turning.
Option A charge
Option B charge
NINCOAIR is brand of NINCO DESARROLLOS S.L.
Ctra. de l'Hospitalet 32
08940 Cornella Barcelona Spain
CIF B-60307725 · www.nincoair.com
HAND BOOK
Canal Tri-banda
Switch Charge/Off/On
Turn right / left
Forward / backward
ENGLISH